The driver is used to control the motor of the MBK series. Torque control: analog signal ±10V speed control: analog signal ±10V position control: pulse +, CCW+CW, A+B phase (5V-24V). The availability of digital inputs allows better programming of the drive for specific applications: you can enable or reset the drive, select control modes, change electronic deceleration ratios, switch gains, command homing, quick-stop, set limit switches, etc. The digital output can be used to monitor the status of the guided shaft. The main features are: power range 100... 3000 W power supply voltage 24-70 V DC, 220 V AC single-phase, 220 V AC three-phase, 380 V AC three-phase RS232 interface,